ProTek RC HV LiPo Hump/Short Receiver Battery Pack (Kyosho/Tekno) (7.6V/2600mAh)

(w/Balancer Plug)

This is a set of four ProTek R/C 1/8 Scale Buggy & 1/10 Truck Tire Mounting Bands. Too often a faulty glue bond can ruin a tire, as well as possibly damage the wheel and insert. This forces you to repair the tire, or worse...buy a new set of tires. With the aid of these Protek R/C Tire Mounting Bands, creating a tight consistent glue bond is easier than ever!
 
These mounting bands are ideal for 1/8 Buggy Tires and 1/10 Short Course and Stadium Truck Tires and will help to make the chore of gluing tires a little easier. The bands apply pressure to the tire and keep the tire bead pressed firmly into the glue channel in the wheel. This eliminates air gaps between the tire and wheel and helps to create a strong glue bond. Plus, six equally spaced pull tabs located along the outer edge of the band allow you to easily move the bands into the position you need them in. Help avoid tomorrow’s headaches; pick up a set of ProTek R/C Tire Mounting Bands today!

Ideal For:

• 1/8 Off-Road Buggy
• 1/10 Off-Road Short Course
• 1/10 Off-Road Stadium Truck

• Specifications:

• Capacity: 2600 mAh
• Case: Lexan shell covered with heat shrink
• Weight: 100 grams (including wire and connector)
• Li-Po cell arrangement: 2S2P
• Nominal voltage: 7.6 Volts
• Discharge capability: 8C continuous (20.8A)
• Dimension (LxWxH): 54x31x31mm
• Connector: JR Style with thick 20AWG Silicone Wire
• Balancer Plug: XH style (Align, E-Flite compatible)
• Recommended Application: Kyosho and Tekno vehicles, 1/10th & 1/8th scale nitro models, Helicopters and Airplanes 

• IMPORTANT:
  1) DO NOT leave the battery in your model when charging
  2) DO NOT leave unattended when charging
  3) ALWAYS balance charge the battery
  4) ALWAYS use a LiPo charging bag
  5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
  6) YOU MUST not over discharge the Li-Poly battery pack
  7) READ & UNDERSTAND the instructions carefully before operating this battery

  NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage.
  
  Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.

• Kyosho MP10
• Kyosho MP9 TKI2
• Kyosho MP9 TKI3
• Kyosho MP9 TKI4
• Tekno RC NB48 2.0
• Tekno RC NB48 2.1
• Tekno RC NB48 Original
• Tekno RC NB48.3
• Tekno RC NT48 2.0
• Tekno RC NT48 Original
• Tekno RC NT48.3